### Author:

  • loc 1 - a bus-organized systems, the control signals that specify microoperations are groups of bits that select the paths in multiplexers, decoders, and arithmetic logic units

  • loc 1 - Microinstruction  Contains a control word and a sequencing word  Control Word - All the control information required for one clock cycle  Sequencing Word - Information needed to decide the next microinstruction address  Vocabulary to write a microprogram

  • loc 2 - Any operation that can be decomposed into a sequence of suboperations of about the same complexity can be implemented by a pipeline processor

  • loc 2 - The behavior of a pipeline can be illustrated with a space-time diagram. o It shows the segment utilization as a function of time

  • loc 2 - Dynamic Microprogramming  Computer system whose control unit is implemented with a microprogram in WCS

  • loc 2 - Writeable Control Memory(Writeable Control Storage:WCS

  • loc 2 - Pipeline Register  The data register is sometimes called a pipeline register

  • loc 2 - This configuration requires a two-phase clock

  • loc 3 - If we assume that the time it takes to process a task is the same in the pipeline and non-pipeline circuits, i.e. , tn = ktp, the speedup reduces to S=ktp/tp=k.  This shows that the theoretical maximum speed up that a pipeline can provide is k, where k is the number of segments in the pipeline

  • loc 3 - The transformation from the instruction code bits to an address in control memory where the routine is located is referred to as a mapping process

  • loc 4 - The purpose of parallel processing is to speed up the computer processing capability and increase its throughput

  • loc 8 - It is important to realize that two or more conflicting microoperations cannot be specified simultaneously.e.g. 010 001 000

  • loc 13 - The method used in most RISC processors is to rely on the compiler to redefine the branches so that they take effect at the proper time in the pipeline. This method is referred to as delayed branch

  • loc 17 - o Attached array processor:  Is an auxiliary processor.  It is intended to improve the performance of the host computer in specific numerical computation tasks. o SIMD array processor:  Has a single-instruction multiple-data organization.  It manipulates vector instructions by means of multiple functional units responding to a common instruction

  • loc 17 - A commercial computer with vector instructions and pipelined floating-point arithmetic operations is referred to as a supercomputer

  • loc 17 - components are packed tightly together

  • loc 17 - measure used to evaluate computers in their ability to perform a given number of floating-point operations per second is referred to as flops.  A typical supercomputer has a basic cycle time of 4 to 20 ns.  The examples of supercomputer:  Cray-1: it uses vector processing with 12 distinct functional units in parallel; a large number of registers (over 150); multiprocessor configuration (Cray X-MP and Cray Y-MP) o Fujitsu VP-200: 83 vector instructions and 195 scalar instructions; 300 megaflops 4.7 Array Processing

  • loc 17 - The advantage of a modular memory is that it allows the use of a technique called interleaving.  In an interleaved memory, different sets of addresses are assigned to different memory modules.  By staggering the memory access, the effective memory cycle time can be reduced by a factor close to the number of modules

  • loc 18 - The objective of the attached array processor is to provide vector manipulation capabilities to a conventional computer at a fraction of the cost of supercomputer

  • loc 18 - A general block diagram of an array processor is shown in Fig.9-15. o It contains a set of identical processing elements (PEs), each having a local memory M. o Each PE includes an ALU, a floating-point arithmetic unit, and working registers. o Vector instructions are broadcast to all PEs simultaneously